Prevention is better than cure

4 Tips for maintaining spray nozzles

tips for maintaining spray nozzles

Tip 1: Damage prevention

If you have purchased and used a spray nozzle, it is important to maintain the spray nozzle properly. Various maintenance tips to ensure maximum service life and optimum performance of your spray nozzle are provided below.

 Carefully read the instructions for use before use.
 Store spray nozzles in their case
 Make sure the hose connection is clean to ensure a good hose connection/seal
 Place the spray nozzle carefully in the sewer

spuitkop riool kopen
bulldog

Tip 2: Bepaal de benodigde waterstralen

 During cleaning in the sewer, never withdraw the spray nozzle without (water) pressure. Otherwise, dirt will get into the nozzle.

Tip 3: Cleaning inserts

 Disassemble the spray nozzle before cleaning the inserts. This prevents the dirt from entering the spray nozzle
 Remove the inserts before cleaning. This is best when they are heated, because the inserts are glued
 Carefully remove the blockage with a spray nozzle pricker
 Glue the inserts back in with Loctite® 243 (or equivalent product)
 Check the operation by observing the water jet. Note: do this without water pressure to avoid injuries.
 Allow the glue sufficient time to dry before using the spray nozzle again (approx. 2 hours)

rom enz spuitkoppen voor de rioolspecialist slagnozzle
riool reinigingskop

Tip 4: Rust prevention

 After use, spray the inserts of the spray nozzles (and chains of the chain scraper) with a preservative. In addition to WD40, you can also use (environmentally-friendly) biodegradable products for this.

ROM ENZ Spray Nozzles Service Centre

To guarantee optimal use and a maximum service life of your spray nozzles, ROM has invested in the knowledge and parts to overhaul and repair all your ROM and ENZ spray nozzles. Our service centre will overhaul and repair your spray nozzles faster and more cheaply. You are assured of expert advice and assistance for repairs when you need them.

To guarantee optimal use and a maximum service life of your spray nozzles, ROM has invested in the knowledge and parts to overhaul and repair all your ROM and ENZ spray nozzles. Our service centre will overhaul and repair your spray nozzles faster and more cheaply. You are assured of expert advice and assistance for repairs when you need them.

Thanks to this large stock and diversity in spray nozzles, we can also adjust your tools to the optimal capacity of your machine at any time. ROM offers you certainty and satisfaction. And that's a reassuring thought.

Would you like to make an appointment for the service of your spray nozzles? Call or mail us.

tips%20om%20spuitkoppen%20te%20onderhouden(1)
rom enz flowmeter

ROM - ENZ Flow meter

Do you want to improve the efficiency of your machine and spray nozzle?  You can have your machine and spray nozzle tested using our flow meter.

Imagine: the pressure in your machine has not been optimal for a while and is not working well. That is quite frustrating because buying your machine was not cheap. ROM offers the solution: have your machine tested using our flow meter for free.

ROM has developed a new test installation to improve the efficiency of your machine: the flow meter. This meter not only provides information about the condition of your machine, but also about the spray nozzles you use. Your machine will be returned to top condition immediately after the test. You will then be able to get back to work just as you just did when you started using the machine. You will be able to clean better and faster, as well as save on your water and fuel consumption and labour costs.

 

Save smart and simple:
 Lower fuel consumption
 Less water consumption
 Lower labour costs
 Less wear on equipment
 Less nuisance for the environment